Work Procedure

CONFIGURATION (CAN GATEWAY)


Work Procedure

1.WRITING MODE SELECTION
CONSULT-III Configuration
Select "CONFIGURATION" of CAN gateway.
When writing saved data-GO TO 2.
When writing manually-GO TO 3.
2.PERFORM "WRITE CONFIGURATION - CONFIG FILE"
CONSULT-III Configuration
Perform "WRITE CONFIGURATION - Config file".
- WORK END
3.PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"
CONSULT-III Configuration
1. Select "WRITE CONFIGURATION - Manual selection".
2. Select "SETTING".
3. When "COMMAND FINISHED", select "End".
- GO TO 4.
4.CHECK "SELF DIAGNOSTIC RESULT"
1. Erase all ECU self-diagnosis results using CONSULT-III.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Perform "All DTC Reading" using CONSULT-III.
5. Check that all ECU self-diagnosis results have no DTC of CAN communication.

NOTE:
DTCs of CAN communication are as follows:
- U0101
- U0140
- U0164
- U1000
- U1001
- U1507
- U1508
- WORK END