Removal And Installation

CONTROL CABLE


Removal and Installation


REMOVAL
1. Remove center console assembly . Removal And Installation.
2. Remove cluster lid C cover and instrument center finisher LH. Removal And Installation.
3. Shift selector lever in "P" position.
4. Remove control cable from A/T shift selector assembly.
5. Remove control cable from manual lever and control cable mounting bracket.





6. Remove retainer mounting bolts ( ) according to the following procedure.
a. Separate propeller shaft assembly (front). Removal And Installation Disassembly And Assembly, "Removal and Installation". (For 4WD models)
b. Disconnect heated oxygen sensor 2 connectors (bank 1 and bank 2). Exploded View.
c. Remove exhaust front tube (RH and LH). Exploded View Removal And Installation, "Exploded View".
d. Remove heat plates above three way catalyst (RH and LH).
e. Remove control cable mounting bracket from A/T assembly.
f. Remove retainer mounting bolts from dash panel.
7. Remove control cable from the vehicle.

INSTALLATION
Note the following, and install in the reverse order of removal.





When installing control cable (1) to A/T shift selector assembly (2), check that control cable is fully pressed in with the ribbed (A) surface facing upward.