Control Module: Service and Repair

TRANSFER CONTROL UNIT


Removal and Installation


REMOVAL
1. Turn the ignition switch OFF.
2. Disconnect negative battery terminal.

CAUTION:
Wait for 5 seconds after turning ignition switch OFF.
3. Remove the glove box assembly. Removal And Installation.
4. Disconnect the transfer control unit connector.
5. Move instrument lower cover to backward. Removal And Installation.
6. Remove the transfer control unit.

INSTALLATION
Note the following, and install in the reverse order of removal.
- When replacing transfer control unit, perform writing unit parameter and initial calibration. Description Work Procedure, "Work Procedure".