B210D
B210D STARTER RELAY
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC B210D is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
Security System.
- If DTC B210D is displayed with DTC B2617, first perform the trouble diagnosis for DTC B2617. Refer to
B2617.
DTC CONFIRMATION PROCEDURE
1. PERFORM DTC CONFIRMATION PROCEDURE
1.Ignition switch ON under the following conditions and wait for at least 1 second.
-Selector lever is in the P or N position.
-Do not depress brake pedal.
2.Check "Self diagnostic result" with CONSULT.
Is DTC detected?
YES- Go to .
NO- INSPECTION END
Diagnosis Procedure
1. INSPECTION START
1.Turn ignition switch ON.
2.Check "Self diagnostic result" for IPDM E/R with CONSULT.
3.Touch "ERASE".
4.Perform DTC Confirmation Procedure.
See .
Is the DTC B210D displayed again?
YES- Replace IPDM E/R. Removal And Installation.
NO- INSPECTION END