B2110

B2110 PNP/CLUTCH INTERLOCK SWITCH

Description

IPDM E/R confirms the shift position with the following signals.
- Transmission range switch
- Shift position signal from BCM (CAN)


DTC Logic


DTC DETECTION LOGIC

NOTE:
If DTC B2110 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Security System.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn the ignition switch ON under the following conditions and wait for at least 1 second.
-Selector lever is in the P or N position.
-Do not depress brake pedal.
2.Check "Self diagnostic result" with CONSULT.
Is DTC detected?
YES- Go to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK DTC WITH TCM

Check "Self diagnostic result" with CONSULT. A L L Diagnostic Trouble Codes ( DTC ).
Is the inspection result normal?
YES- GO TO 2.
NO- Repair or replace the malfunctioning parts.

2. CHECK TRANSMISSION RANGE SWITCH INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect IPDM E/R connector.
3.Turn ignition switch ON.
4.Check voltage between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES- Replace IPDM E/R. Removal And Installation.
NO- GO TO 3.

3. CHECK TRANSMISSION RANGE SWITCH CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect TCM connector.
3.Check continuity between IPDM E/R harness connector and TCM harness connector.





4.Check continuity between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace harness or connector.

4. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END