B2560

B2560 STARTER CONTROL RELAY

Description

Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position. It is installed in parallel with the starter relay.


DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC B2560 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
Security System
- If DTC B2560 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
Security System.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON under the following conditions and wait for at least 2 seconds.
-Selector lever is in the P or N position.
-Do not depress brake pedal.
2.Check "Self diagnostic result" with CONSULT.
Is DTC detected?
YES- Go to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK DTC WITH IPDM E/R

Check "Self diagnostic result" with CONSULT. A L L Diagnostic Trouble Codes ( DTC ).
Is the inspection result normal?
YES- GO TO 2.
NO- Replace IPDM E/R. Removal And Installation.

2. CHECK INTERMITTENT INCIDENT

Intermittent Incident
- INSPECTION END