Operation CHARM: Car repair manuals for everyone.

ICC (Full Speed Range)




C1A08 PRESSURE SENSOR

Description

- The brake pressure sensor detects the brake fluid pressure value in the brake master cylinder and outputs the value to the brake booster control unit.
- The brake booster control unit receives the brake fluid pressure command signal from the ICC sensor integrated unit via ITS communication and controls the brake fluid pressure while feeding back the brake fluid pressure value (brake fluid pressure control signal).


DTC Logic


DTC DETECTION LOGIC






NOTE:
If DTC "C1A08" is detected along with DTC "U1000", first diagnose the DTC "U1000". Cruise Control ICC (Full Speed Range).

DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Start the engine.
2.Turn the MAIN switch of ICC system ON.
3.Perform "All DTC Reading" with CONSULT.
4.Check if the "C1A08" is detected as the current malfunction in "Self Diagnostic Result" of "ICC/ADAS".
Is "C1A08" detected as the current malfunction?
YES- .
NO- Intermittent Incident.


Diagnosis Procedure


1. CHECK SELF-DIAGNOSIS RESULTS

Check if "U1000" is detected other than "C1A08" in "Self Diagnostic Result" of "ICC/ADAS".
Is "U1000" detected?
YES- Perform the CAN communication system inspection. Repair or replace the malfunctioning parts.
Cruise Control ICC (Full Speed Range).
NO- GO TO 2.

2. CHECK HARNESS BETWEEN BRAKE BOOSTER CONTROL UNIT AND BRAKE PRESSURE SENSOR

1.Turn the ignition switch OFF.
2.Disconnect connectors of brake booster control unit and brake pressure sensor.
3.Check for continuity between the brake booster control unit harness connector and brake pressure sensor harness connector.





4.Check for continuity between brake booster control unit harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair the harnesses or connectors.

3. CHECK BRAKE PRESSURE SENSOR POWER SUPPLY CIRCUIT

1.Connect connectors of brake booster control unit and brake pressure sensor.
2.Turn the ignition switch ON.
3.Check voltage between brake booster control unit harness connectors.





Is the inspection result normal?
YES- Replace the brake pressure sensor.
NO- Replace the brake booster control unit.


Special Repair Requirement


DESCRIPTION

Perform the action test after adjusting the laser beam aiming of ICC sensor integrated unit when the following operation is performed.
- Removal and installation of ICC sensor integrated unit
- Replacement of ICC sensor integrated unit

SPECIAL REPAIR REQUIREMENT


1. LASER BEAM AIMING ADJUSTMENT OF ICC SENSOR INTEGRATED UNIT

Adjust the laser beam aiming of the ICC sensor integrated unit. Description.
- GO TO 2.

2. CHECK ICC SYSTEM

1.Erase the "Self Diagnostic Result", and then perform "All DTC Reading" again after performing the action test. (Description for action test.)
2.Check that the ICC system is normal.
- WORK END