P1238

P1238, P2119 ELECTRIC THROTTLE CONTROL ACTUATOR

Description

Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc.
The throttle control motor is operated by the ECM and it opens and closes the throttle valve.
The throttle position sensor detects the throttle valve position, and the opening and closing speed of the throttle valve and feeds the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and the ECM controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition.


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A AND B

1.Turn ignition switch ON and wait at least 1 second.
2.Shift selector lever to D position and wait at least 3 seconds.
3.Shift selector lever to P position.
4.Turn ignition switch OFF and wait at least 10 seconds.
5.Turn ignition switch ON and wait at least 1 second.
6.Shift selector lever to D position and wait at least 3 seconds.
7.Shift selector lever to P position.
8.Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
9.Check DTC.
Is DTC detected?
YES- Go to .
NO- GO TO 3.

3. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C

1.Turn ignition switch ON and wait at least 1 second.
2.Shift selector lever to D position and wait at least 3 seconds.
3.Shift selector lever to P position.
4.Start engine and let it idle for 3 seconds.
5.Check DTC.
Is DTC detected?
YES- Go to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY

1.Turn ignition switch OFF.
2.Remove the intake air duct.





3.Check if foreign matter is caught between the throttle valve (1)
and the housing.
Is the inspection result normal?
YES- GO TO 2.
NO- Remove the foreign matter and clean the electric throttle control actuator inside, and then perform throttle valve closed position learning. Refer to {LINK_TO_MANY:0000000007455851}{LINK_TO_MANY:0000000007455852}{LINK_TO_MANY:0000000007455853}{LINK_TO_MANY:0000000007455854}{LINK_TO_MANY:0000000007455855}, "THROTTLE
VALVE CLOSED POSITION LEARNING : Special
Repair Requirement".

2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

1.Replace malfunctioning electric throttle control actuator.
2.Go to .
- INSPECTION END


Special Repair Requirement


1. PERFORM THROTTLE VALVE CLOSED POSITION LEARNING

Special Repair Requirement
- GO TO 2.

2. PERFORM IDLE AIR VOLUME LEARNING

Special Repair Requirement
- END