Removal And Installation

CENTER CONSOLE ASSEMBLY

Removal and Installation


CAUTION:
When removing, always use a remover tool that is made of plastic.

REMOVAL

1.Remove console finisher assembly.
1.Put selector lever in drive position.
2.Remove selector lever knob. Removal And Installation.





3.Pull console finisher (1), upward to disengage from center console.
4.Disconnect harness connectors.










2.Disconnect console sub harness connectors (A).
3.Remove center console assembly fixing screws (B).





4.Remove console center finisher.
1.Open the console lid assembly.
2.Remove console pocket.
3.Pull upward to release console center finisher fixing pawls from center console assembly.
4.Disconnect harness connectors.










5.Remove console rear finisher.
1.Put front seat to frontmost position.
2.Pull back the console rear finisher (1) with remover tool (A).
3.Disconnect inside key antenna connector.










6.Remove rear ventilator duct 2 (1). Rear Ventilator Duct 2.
7.Remove center console assembly fixing screws (A).
8.Remove center console assembly.
1.Put front seat to rearmost position.
2.Lift up center console assembly back side.
3.Disconnect harness connectors.

INSTALLATION

Install in the reverse order of removal.