Operation CHARM: Car repair manuals for everyone.

C1754




Description






- After the low tire pressure warning control unit (1) receives the tire pressure signal from the tire pressure receiver, it controls the operation of the low tire pressure warning lamp and buzzer.
- Performs self-diagnosis of the Tire Pressure Monitoring System (TPMS).


DTC Logic


DTC logic







DTC REPRODUCTION PROCEDURE


1. DTC REPRODUCTION PROCEDURE

With CONSULT
1.Drive for several minutes at a speed of 40 km/h (25 MPH) or more, then stop the vehicle.
2.Stop the vehicle and perform "AIR PRESSURE MONITOR" self-diagnosis.
Is DTC "C1754" detected?
YES- Perform trouble diagnosis. .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK POWER VOLTAGE

1.Turn the ignition switch OFF.
2.Disconnect the low tire pressure warning control unit harness connector.
3.Check the voltage between the harness connectors of the low tire pressure warning control unit and the ground.





Is the inspection result normal?
YES- GO TO 2.
NO-If the results of any of the following check items are not normal, repair or replace the malfunctioning part.
- 10A fuse [No. 3 in fuse block (J/B)]
- Harness open circuit or short circuit between the ignition switch and harness connector terminal
15 of the low tire pressure warning control unit.
- Check battery voltage.

2. CHECK GROUND CIRCUIT

Check the continuity between the low tire pressure warning control unit harness connector and ground.





Are the check results normal?
YES- GO TO 3.
NO- If an open circuit or other damage is detected, malfunctioning part.

3. CHECK LOW TIRE PRESSURE WARNING CONTROL UNIT AND TIRE PRESSURE RECEIVER CIRCUIT

1.Check the continuity between the low tire pressure warning control unit harness connector and tire pressure receiver harness connector.





2.Check the continuity between the low tire pressure warning control unit harness connector and ground.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace error-detected parts.

4. PERFORM THE SELF-DIAGNOSIS

With CONSULT
1.Perform tire pressure sensor ID registration for all wheels. Work Procedure.
2.Perform "AIR PRESSURE MONITOR" self-diagnosis.
Is DTC "C1754" detected?
YES- Replace the low tire pressure warning control unit.
NO- Check for looseness or damage at the harness connector pins of the low tire pressure warning control unit. Repair or replace if necessary.


Special Repair Requirement


1. CHECK TIRE PRESSURE

Check the tire pressure of all wheels. [1][2]Specifications.
Does the tire pressure match the specified value?
YES- GO TO 2.
NO- Check the road wheels and tires. Adjust the tire pressures to the specified values.

2. REGISTER TIRE PRESSURE SENSOR ID

Perform tire pressure sensor ID registration. Work Procedure.
- END