C1923

C1923 STEERING ANGLE SENSOR

Description

Steering angle sensor signal is transmitted from steering angle sensor to RAS control unit via CAN communication.


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. DTC REPRODUCTION PROCEDURE

With CONSULT
1.Drive at 60 km/h (37 MPH) or more for 3 minutes or more.
2.Perform "4WAS(MAIN)/RAS/HICAS" self-diagnosis.
Without CONSULT
1.Drive at 60 km/h (37 MPH) or more for 3 minutes or more.
2.Perform the self-diagnosis. Diagnosis Description.
Is DTC "C1923" or "RAS warning lamp flickering pattern: 22" detected?
YES- Proceed to diagnosis procedure. .
NO- INSPECTION END


Diagnosis Procedure


1. PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS

With CONSULT
1.Drive at 60 km/h (37 MPH) or more for 3 minutes or more.
2.Perform "ABS" self-diagnosis.
Is any error system detected?
YES- Check the error system.
NO- GO TO 2.

2. PERFORM SELF-DIAGNOSIS

With CONSULT
Perform "4WAS(MAIN)/RAS/HICAS" self-diagnosis.
Is DTC "U1000" or "U1010" detected?
YES- Check the error system.
NO- GO TO 3.

3. PERFORM SELF-DIAGNOSIS

With CONSULT
1.Drive at 60 km/h (37 MPH) or more for 3 minutes or more.
2.Perform "4WAS(MAIN)/RAS/HICAS" self-diagnosis.
Without CONSULT
1.Drive at 60 km/h (37 MPH) or more for 3 minutes or more.
2.Perform the self-diagnosis. Diagnosis Description.
Is DTC "C1923" or "RAS warning lamp flickering pattern: 22" detected?
YES- Replace RAS control unit. RAS Control Unit.
NO- GO TO 4.

4. INFORMATION CHECK

With CONSULT
1.Select "DATA MONITOR" of "4WAS(MAIN)/RAS/HICAS".
2.Check the "DATA MONITOR" value of each DTC detected with the self-diagnosis function. With Rear Active Steer.
Is each data the standard value?
YES- Check that there is no malfunction in each harness connector pin terminal or disconnection.
NO- Replace RAS control unit. RAS Control Unit.


Special Repair Requirement


BEFORE REPLACING RAS CONTROL UNIT

- Record the self-diagnosis results (history).

CAUTION:
- Never erase the memory (history) of self-diagnosis results when replacing RAS control unit after diagnosis.
- Erase the memory of the self-diagnosis results (record) after printing out or recording all the values of "DATA MONITOR".