Operation CHARM: Car repair manuals for everyone.

P1238




P1238, P2119 ELECTRIC THROTTLE CONTROL ACTUATOR

Description

Electric throttle control actuator consists of throttle control motor, throttle position sensor, etc.
The throttle control motor is operated by the ECM and it opens and closes the throttle valve.
The throttle position sensor detects the throttle valve position, and the opening and closing speed of the throttle valve and sends the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and opens/closes the throttle valve in response to driving conditions via the throttle control motor.


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A AND B

1.Turn ignition switch ON and wait at least 1 second.
2.Shift selector lever position to D and wait at least 3 seconds.
3.Shift selector lever position to P.
4.Turn ignition switch OFF and wait at least 10 seconds.
5.Turn ignition switch ON and wait at least 1 second.
6.Shift selector lever position to D and wait at least 3 seconds.
7.Shift selector lever position to P.
8.Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
9.Check DTC.
Is DTC detected?
YES- Proceed to .
NO- GO TO 3.

3. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C

1.Turn ignition switch ON and wait at least 1 second.
2.Shift selector lever position to D and wait at least 3 seconds.
3.Shift selector lever position to P.
4.Start engine and let it idle for 3 seconds.
5.Check DTC.
Is DTC detected?
YES- Proceed to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY

1.Turn ignition switch OFF.
2.Remove the intake air duct. Service and Repair.





3.Check if foreign matter is caught between the throttle valve (1)
and the housing.
Is the inspection result normal?
YES- GO TO 2.
NO- Remove the foreign matter and clean the electric throttle control actuator inside, and then perform throttle valve closed position learning. Refer to {LINK_TO_MANY:0000000007514918}{LINK_TO_MANY:0000000007514919}{LINK_TO_MANY:0000000007514920}{LINK_TO_MANY:0000000007514921}, "THROTTLE
VALVE CLOSED POSITION LEARNING : Special
Repair Requirement".

2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

Replace malfunctioning electric throttle control actuator. Removal And Installation.
- INSPECTION END