7AT RE7R01B TP Sensor

P1705 TP SENSOR

Description

- The accelerator pedal position sensor is installed on the upper end of the accelerator pedal assembly.
- The accelerator pedal position sensor detects the accelerator position.
- The accelerator pedal position sensor transform the accelerator pedal position into output voltage, and emit the voltage signal to the ECM.
- The TCM receives accelerator pedal position signal from the ECM via CAN communication.


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


CAUTION:
Always drive vehicle at a safe speed.

1. PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. CHECK DTC DETECTION

With CONSULT
1.Start the engine.
2.Select "SLCT LVR POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3.Drive vehicle and maintain the following conditions for 5 seconds or more.





4.Perform "Self Diagnostic Results" in "TRANSMISSION".
Is "P1705" detected?
YES- Go to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK DTC OF ECM

With CONSULT
1.Turn ignition switch ON.
2.Perform "Self Diagnostic Results" in "ENGINE".
Is any DTC detected?
YES- Check DTC detected item. A L L Diagnostic Trouble Codes ( DTC ).
NO- GO TO 2.

2. CHECK DTC OF TCM

With CONSULT
Perform "Self Diagnostic Results" in "TRANSMISSION".
Is any DTC other than "P1705" detected?
YES- Check DTC detected item. A L L Diagnostic Trouble Codes ( DTC ).
NO- GO TO 3.

3. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
Is the inspection result normal?
YES- Replace control valve & TCM. Exploded View.
NO- Repair or replace damaged parts.