Work Procedure

CONFIGURATION (CAN GATEWAY)

Work Procedure


1. WRITING MODE SELECTION

CONSULT Configuration
Select "CONFIGURATION" of CAN gateway.
When writing saved data-GO TO 2.
When writing manually-GO TO 3.

2. PERFORM "WRITE CONFIGURATION - CONFIG FILE"

CONSULT Configuration
Perform "WRITE CONFIGURATION - Config file".
- GO TO 4.

3. PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"

CONSULT Configuration
1.Select "WRITE CONFIGURATION - Manual selection".
2.Select "SETTING".
3.When "COMMAND FINISHED", select "End".
- GO TO 4.

4. CHECK "SELF DIAGNOSTIC RESULT"

1.Erase all ECU self-diagnosis results using CONSULT.
2.Turn the ignition switch OFF.
3.Turn the ignition switch ON and wait for 2 seconds or more.
4.Perform "All DTC Reading" using CONSULT.
5.Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
- WORK END