Removal and Installation

A/T SHIFT SELECTOR

Removal and Installation


REMOVAL

1.Remove control rod from A/T shift selector assembly.
2.Shift the selector lever to "N" position.





3.Remove knob cover (A) below selector lever downward.
4.Pull lock pin (1) out of selector lever knob (2).
5.Remove selector lever knob.
6.Remove console finisher assembly and center console assembly. Refer to "Removal and Installation" Removal and Installation.

CAUTION:
When disconnecting selector lever position indicator connector from shift position switch, never twist or apply an excessive load to the connector.
7.Remove the rear ventilator duct 1 (with rear ventilation). Refer to "REAR VENTILATOR DUCT 1 : Removal and Installation" Rear Ventilator Duct 1.
8.Disconnect A/T shift selector harness connector.
9.Remove harness clips from A/T shift selector assembly.
10.Shift the selector lever to "P" position.
11.Move passengers seat to the end.
12.Remove A/T shift selector assembly mounting bolts.





13.Slightly lift the A/T shift selector assembly (1) and slide it rightward. Then pull it out in the diagonally right direction.
14.Remove adapter from A/T shift selector assembly.
15.Remove dust cover and dust cover plate from A/T shift selector assembly.
16.Remove dust cover plate from dust cover.
17.Remove shift lock unit from A/T shift selector assembly.
18.Remove bracket from vehicle floor panel.
19.Remove selector lever position indicator from console finisher assembly.





a.Remove ashtray (front) (1) from console finisher assembly.










b.Remove insert finisher (1) from console finisher assembly.










c.Remove the selector lever position indicator (1).






INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
- Apply multi-purpose grease on the pin surface (that slides after installing a collar) of the pivot pin.
- Apply multi-purpose grease on the surface that the shift lock unit plate slides vertically.
- Refer to the followings when installing the selector lever knob to the A/T shift selector assembly.
1.Install the lock pin to the selector lever knob.
2.Insert the shift lever knob into the shift lever until it clicks.

CAUTION:
- Install it straight, and never tap or apply any shock to install it.
- Never press selector button.