Automatic Drive Positioner Control Unit

POWER SUPPLY AND GROUND CIRCUIT

AUTOMATIC DRIVE POSITIONER CONTROL UNIT : Diagnosis Procedure

NOTE:
Do not disconnect the battery negative terminal and the driver seat control unit connector until DTC is confirmed with CONSULT.

1. CHECK POWER SUPPLY CIRCUIT

1.Turn ignition switch OFF.
2.Check voltage between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES- GO TO 2.
NO- Repair or replace harness between automatic drive positioner control unit and fuse block (J/B).

2. CHECK GROUND CIRCUIT

Check continuity between the automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES- Automatic drive positioner control unit power supply and ground circuit are OK.
NO- Repair or replace harness between automatic drive positioner control unit and ground.