Operation CHARM: Car repair manuals for everyone.

Removal and Installation




FLUID COOLER SYSTEM

2WD : Removal and Installation


REMOVAL

1.Remove engine lower cover with power tool. Refer to "Removal and Installation" Removal and Installation.
2.Remove A/T fluid cooler hose A and A/T fluid cooler hose B.
3.Remove A/T fluid cooler tubes from A/T assembly and engine.
4.Plug up opening such as the A/T fluid cooler tube hole.
5.Remove A/T fluid cooler tubes from the vehicle.

CAUTION:
Be careful not to bend A/T fluid cooler tubes.
6.Remove clips and bracket.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
Never reuse copper washer.
- Refer to the following when installing A/T fluid cooler hoses.










- The illustrations indicate the view from the hose ends.





- When installing hose clamps center line of each hose clamp tab should be positioned as shown in the figure.
- Insert A/T fluid cooler hoses according to dimension "L" described below.















- Set hose clamps (1) at the both ends of A/T fluid cooler hoses (2)
with dimension "A" from the hose edge.





- Hose clamp should not interfere with the bulge of fluid cooler tube.