Removal and Installation

FRONT BUMPER

Removal and Installation


REMOVAL


CAUTION:
Bumper fascia is made of resin. Use care when handling to prevent damage. Avoid contact with oily substances.
1.Open hood.





2.Remove the core support cover clips (A), then remove the core support cover (1).
3.Partially remove the front fender protectors (LH/RH). Refer to "FENDER PROTECTOR : Removal and Installation" Removal and Installation.
4.Remove the front under cover. Refer to "Removal and Installation" Removal and Installation.





5.Remove the front bumper fascia to upper fender screw (A) (LH/
RH), then remove front fascia upper bracket (1).
Revision: March 20122013 Infiniti JX





6.Remove the front bumper fascia to fender screw (A) (LH/RH).
7.Disconnect the harness connectors from front sonar sensors outer (LH/RH) and fog lamps (LH/RH).
8.Release the front bumper fascia from the side brackets (LH/RH).





: Pawl
9.Remove the front bumper fascia.

CAUTION:
When removing front bumper fascia, two people are required to avoid damaging.
10.Remove the following parts after removing front bumper fascia.
- Front fascia lower grille
- Front bumper grille
- Front sonar sensor outer (LH/RH). Refer to "Removal and Installation" With Surround Sound.
- Front fog lamp assemblies (LH/RH). Refer to "Removal and Installation" Removal and Installation.
- Front fog lamp finishers (LH/RH)
- Front bumper side brackets (LH/RH)
- Front license plate bracket
11.Remove the front bumper fascia upper retainer bracket.

INSTALLATION

Installation is in the reverse order of removal.
NOTE:
- The following table shows the specified values for checking normal installation status.
- Fitting adjustment cannot be performed.
Revision: March 20122013 Infiniti JX





mm (in)





Revision: March 20122013 Infiniti JX