Driver Seat Control Unit

POWER SUPPLY AND GROUND CIRCUIT

DRIVER SEAT CONTROL UNIT : Diagnosis Procedure

NOTE:
Do not disconnect the battery negative terminal and the driver seat control unit connector until DTC is confirmed with CONSULT.
Regarding Wiring Diagram information, refer to "Wiring Diagram" [1][2]Electrical Diagrams.
Revision: March 20122013 Infiniti JX

1. CHECK POWER SUPPLY CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect driver seat control unit.
3.Check voltage between driver seat control unit harness connector and ground.





Is the inspection result normal?
YES- GO TO 2.
NO-Check the following.
- Repair or replace harness.
- Circuit breaker-2.

2. CHECK GROUND CIRCUIT

Check continuity between the driver seat control unit harness connector and ground.





Is the inspection result normal?
YES- Inspection End.
NO- Repair or replace harness.