Sliding Motor

SLIDING MOTOR

Description

- The sliding motor LH is installed to the seat frame.
- The sliding motor LH is activated with the driver seat control unit.
- The seat is slid forward/backward by changing the rotation direction of sliding motor LH.


Component Function Check


1. CHECK FUNCTION

1.Select "SEAT SLIDE" in "ACTIVE TEST" mode with CONSULT.
2.Check the sliding motor LH operation.





Is the operation of relevant parts normal?
YES- Inspection End.
NO- Perform diagnosis procedure. Refer to "Diagnosis Procedure" .


Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" [1][2]Electrical Diagrams.

1. CHECK SLIDING MOTOR LH POWER SUPPLY

1.Turn the ignition switch to ACC.
2.Perform "ACTIVE TEST" ("SEAT SLIDE") with CONSULT.
3.Check voltage between driver seat control unit harness connector and ground.





Is the inspection result normal?
YES- Replace sliding motor LH. Refer to "Removal and Installation" Removal and Installation.
NO- GO TO 2.

2. CHECK SLIDING MOTOR LH CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect driver seat control unit and sliding motor LH.
3.Check continuity between driver seat control unit harness connector and sliding motor LH harness connector.
Revision: March 20122013 Infiniti JX





4.Check continuity between driver seat control unit harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace harness.

3. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
Is the inspection result normal?
YES- Replace driver seat control unit. Refer to "Removal and Installation" Service and Repair.
NO- Repair or replace the malfunctioning part.
Revision: March 20122013 Infiniti JX