Removal and Installation (LH)

ROCKER COVER

Removal and Installation (LH)


REMOVAL

1.Remove the engine room cover. Refer to "Removal and Installation" Exploded View.
2.Remove blow by hose from rocker cover.





3.Remove camshaft position sensor.

CAUTION:
- Handle carefully to avoid dropping and shocks.
- Do not disassemble.
- Do not allow metal powder to adhere to magnetic part at sensor tip (A).
- Do not place sensor in a location where they are exposed to magnetism.
4.Unclip the camshaft position sensor harness retainers.
5.Remove the ignition coils. Refer to "Removal and Installation LH" LH.

CAUTION:
Do not shock ignition coils.
Revision: March 20122013 Infiniti JX





6.Remove LH rocker cover bolts from cylinder head in the reverse order shown.





7.Remove the rocker cover and gasket.

INSTALLATION

Installation is in the reverse order of removal.





- Apply sealant to the areas on the front corners using Tool.
- Use Genuine Silicone RTV Sealant or equivalent. Refer to "Recommended Chemical Products and Sealants" Recommended Chemical Products and Sealants.





CAUTION:
- Installation should be done within 5 minutes after applying liquid gasket.
- Do not fill the engine with oil for at least 30 minutes after the components are installed to allow the sealant to cure.





- Tighten the rocker cover bolts to specification in two steps in order shown.