Work Procedure

INSPECTION AND ADJUSTMENT

ADDITIONAL SERVICE WHEN REPLACING TCU : Work Procedure


1. READING OF VIN DATA

CONSULT work support
Select SAVE VIN DATA, then START on SAVE VIN DATA screen to save the VIN data stored in replaced TCU
in CONSULT. If it cannot be saved, writing operation must be performed manually.
- GO TO 2.

2. TCU REPLACEMENT

Replace TCU. Refer to "Removal and Installation" Service and Repair.
- GO TO 3.

3. NOTICE TO CARRIER ATX HELP DESK

Contact ATX help desk to notice the termination of replaced TCU and connection of new TCU. (VIN is required)
Can ID data be saved to CONSULT at 1st step?
YES- GO TO 4.
NO- GO TO 5.

4. AUTOMATIC WRITING OF VIN DATA TO TCU

CONSULT work support
Select WRITE VIN DATA, then START at WRITE SAVED VIN DATA screen to write the VIN data saved in
CONSULT into new TCU.
- GO TO 6.

5. MANUAL WRITING OF VIN DATA TO TCU

CONSULT work support
Select VIN REGISTRATION, WRITE VIN DATA then START on changing screen to write the VIN data saved into new TCU.
- GO TO 6.

6. TCU ACTIVATION

CONSULT work support
1.Wait for 5 seconds or more after turning the power switch ON.
2.Touch TELEMATICS on the CONSULT screen.
3.After performing System Call of CONSULT, touch the Work support tab.
4.On the work support screen of CONSULT, select TCU ACTIVATE SETTING and touch Start.
5.On the TCU ACTIVATE SETTING screen, touch Start to set to ON. Touch End.
6.Exit from CONSULT.
7.Turn the power switch OFF.
8.Wait (at least 10 seconds) until the power switch indicator turns OFF to shut down TCU.
Revision: March 20122013 Infiniti JX
- WORK END.
Revision: March 20122013 Infiniti JX