Removal and Installation
FRONT PASSENGER AIR BAG MODULE
Removal and Installation
WARNING:
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Always work from the side of air bag module. Do not work in front of it.
- Do not use air tools or electric tools for servicing.
REMOVAL
1.Disconnect both the negative and positive battery terminals, then wait at least three minutes. Refer to PG92, "Removal and Installation".
2.Remove the instrument panel assembly. Refer to "Removal and Installation" Removal and Installation.
3.Remove the front passenger air bag module screws.
Revision: March 20122013 Infiniti JX
4.Disconnect the front passenger air bag module pawls using a suitable tool (A) as shown.
5.Lift up on the front passenger air bag module to remove the front passenger air bag module as shown.
CAUTION:
- Always place the front passenger air bag module with the pad side facing upward as shown.
: Upward
- Replace the front passenger air bag module if it has been dropped or sustained an impact.
- Do not strike the front passenger air bag module.
- Do not insert any foreign objects (screwdriver, etc.) into the front passenger air bag module.
- Do not disassemble the front passenger air bag module.
- Do not expose the front passenger air bag module to temperatures exceeding 90 �C (194 �F).
- Do not allow oil, grease, detergent, or water to come in contact with the front passenger air bag module.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse the front passenger air bag module bolts.
- Do not damage the front passenger air bag module harness during installation.
- After installation is complete, check that no system malfunction is detected causing the air bag warning lamp to illuminate.
- If a malfunction is indicated by the air bag warning lamp after repair or replacement of the malfunctioning parts, perform the SRS final check. Refer to "SRS Final Check" SRS Final Check.
Revision: March 20122013 Infiniti JX