Operation CHARM: Car repair manuals for everyone.

Millimeter Wave Sensor Adjustment




MILLIMETER WAVE SENSOR ALIGNMENT

Millimeter Wave Sensor Adjustment


DESCRIPTION

- Adjust the radar alignment in a vertical direction with CONSULT as per the following.
- The radar alignment in the horizontal direction is performed automatically and cannot be adjusted manually.

CAUTION:
- Never look directly into or block the millimeter wave sensor source (between the front fascia and ICC
target board) during the radar alignment procedure.
- Perform all necessary work for radar alignment procedure until the adjustment completes as shown in the procedure. If the procedure is started but not completed, the ICC system is rendered inoperable.

1. SET CONSULT TO THE RADAR ALIGNMENT MODE

1.Place ignition switch in the ON position.
2.Connect CONSULT and select "LASER/RADAR", then "Work Support".
3.Select "RADAR Alignment".
4.Select "START" after the "RADAR Alignment" screen is displayed.
NOTE:
If the adjustment screen does not appear within approximately 10 seconds after "RADAR Alignment" is selected, the following causes are possible.
- The ICC target board is not installed in the correct position.
Revision: March 20122013 Infiniti JX
- Adequate space is not secured around the ICC target board.
- The radar alignment procedure exceeds its proper installation range.
- Deformation of vehicle body.
- Deformation of unit.
- Deformation of bracket.
- The area is not suitable for the adjustment work.
- Right front side of fascia (millimeter wave sensor view) is not clean.
- The ICC system warning lamp illuminates.
- Go to 2.

2. RADAR ALIGNMENT

1.Once the radar alignment procedure is started, you will be prompted by the CONSULT for the next instruction.
2.Follow all the instructions exactly as requested by the CONSULT which will include the following:





-Adjust ICC target board to position 1 (top tilted toward vehicle)
-Adjust ICC target board to position 2 (vertical position)
-Adjust ICC target board to position 3 (top tilted away from vehicle)





3.You will be prompted with specific instructions to perform physical adjustment to the sensor which may include turning the screw driver (A) by a certain number of turns (B) in increments of 0.25 in either direction.

CAUTION:
Be careful not to cover the right front side of the fascia (millimeter wave sensor view) with a hand or any other body part during adjustment.
- GO TO 3.

3. RADAR ALIGNMENT CONFIRMATION

1.When the "U/D CORRECT" value is executed and the "ADJ VALUE" has been performed, touch "END".
2.When "COMPLETED THE VERTICAL AIMING OF LASER BEAM" display appears, touch "END".

CAUTION:
Always check that the value of "U/D CORRECT" remains accurate (within specification) when the millimeter wave sensor is left alone for at least 2 seconds.
3.Check that "ADJUSTING AUTOMATIC HORIZONTAL LASER BEAM AIMING" is displayed and wait for a short period of time. (The maximum: Approx 10 seconds).
4.Check that "Normally Completed" is displayed, and select "End" to end "RADAR Alignment".

CAUTION:
Once "RADAR Alignment" is started with CONSULT, always continue the work until the radar alignment is completed successfully. If the job is stopped midway, the radar alignment is not completed and the ICC system is rendered inoperative.
5.Confirm proper radar alignment by following CONSULT steps until it shows "ADJ VALUE" to be 0.00 turn.
- Alignment End.
Revision: March 20122013 Infiniti JX