Work Procedure (Group A)

HOW TO ERASE PERMANENT DTC

Work Procedure (Group A)






Revision: March 20122013 Infiniti JX






1. CHECK DTC

Check DTC.
Is any DTC detected?
YES- Repair malfunction(s) and erase DTC. Refer to "On Board Diagnosis Function" On Board Diagnosis Function or "CONSULT Function" Consult Function.
NO- GO TO 2.

2. CHECK PERMANENT DTC

With CONSULT
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
4.Turn ignition switch ON.
5.Select "PERMANENT DTC STATUS" mode with CONSULT.
With GST
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
4.Turn ignition switch ON.
5.Select Service $0A with GST.
Is any permanent DTC detected?
YES- GO TO 3.
NO- END

3. PERFORM DTC CONFIRMATION PROCEDURE

Perform "DTC CONFIRMATION PROCEDURE" for DTCs which are the same as permanent DTCs stored in
ECM. Refer to "DTC Index" A L L Diagnostic Trouble Codes ( DTC ).
- GO TO 4.

4. CHECK PERMANENT DTC

With CONSULT
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
4.Turn ignition switch ON.
5.Select "PERMANENT DTC STATUS" mode with CONSULT.
With GST
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
4.Turn ignition switch ON.
5.Select Service $0A with GST.
Is any permanent DTC detected?
YES- GO TO 1.
NO- END
Revision: March 20122013 Infiniti JX