For Mexico

P0122, P0123 TP SENSOR

DTC Logic


DTC DETECTION LOGIC

NOTE:
If DTC P0122 or P0123 is displayed with DTC P0643, perform the trouble diagnosis for DTC P0643.
Refer to "DTC Logic" For Mexico.






DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:


Before performing the following procedure, confirm that battery voltage is 8 V or more at idle.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

1.Start engine and let it idle for 1 second.
2.Check DTC.
Is DTC detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK THROTTLE POSITION SENSOR 2 POWER SUPPLY CIRCUIT

1.Disconnect electric throttle control actuator harness connector.
2.Turn ignition switch ON.
3.Check the voltage between electric throttle control actuator harness connector and ground.





Is the inspection result normal?
YES- GO TO 2.
NO- Repair open circuit, short to ground or short to power in harness or connectors.

2. CHECK THROTTLE POSITION SENSOR 2 GROUND CIRCUIT FOR OPEN AND SHORT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connector.
3.Check the continuity between electric throttle control actuator harness connector and ECM harness connector.





4.Also check harness for short to ground and short to power.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair open circuit, short to ground or short to power in harness or connectors.

3. CHECK THROTTLE POSITION SENSOR 2 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

1.Check the continuity between electric throttle control actuator harness connector and ECM harness connector.





2.Also check harness for short to ground and short to power.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair open circuit, short to ground or short to power in harness or connectors.

4. CHECK THROTTLE POSITION SENSOR

Refer to "Component Inspection (Throttle Position Sensor)" .
Is the inspection result normal?
YES- GO TO 6.
NO- GO TO 5.

5. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

Replace electric throttle control actuator. Refer to "Removal and Installation" Removal and Installation.
- INSPECTION END

6. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END


Component Inspection (Throttle Position Sensor)


1. CHECK THROTTLE POSITION SENSOR

1.Turn ignition switch OFF.
2.Reconnect all harness connectors disconnected.
3.Perform "Work Procedure" For Mexico.
4.Turn ignition switch ON.
5.Set selector lever position to D.
6.Check the voltage between ECM harness connector terminals under the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- GO TO 2.

2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

Replace electric throttle control actuator. Refer to "Removal and Installation" Removal and Installation.
- INSPECTION END