For Mexico

P1225 TP SENSOR

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:


Before performing the following procedure, confirm that battery voltage is 10 V or more at idle.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON.
2.Turn ignition switch OFF and wait at least 10 seconds.
3.Turn ignition switch ON.
4.Check 1st trip DTC.
Is 1st trip DTC detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK ELECTRIC THROTTLE CONTROL ACTUATOR VISUALLY

1.Turn ignition switch OFF.
2.Remove the intake air duct.
3.Check if foreign matter is caught between the throttle valve and the housing.
Is the inspection result normal?
YES- GO TO 2.
NO- Remove the foreign matter and clean the electric throttle control actuator inside, then perform throttle valve closed position learning. Refer to "Work Procedure" For Mexico.

2. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

Replace electric throttle control actuator. Refer to "Removal and Installation" Removal and Installation.
- INSPECTION END