Blind Spot Warning & Blind Spot Intervention

ACTION TEST

Work Procedure


WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:
Fully understand the following items well before the road test;
- Precautions: Refer to "Precaution for Blind Spot Warning/Blind Spot Intervention System Service" Precaution For Blind Spot Warning/Blind Spot Intervention System Service.
- System description for Blind Spot Warning: Refer to "BLIND SPOT WARNING (BSW) SYSTEM : System Description" System Description.
- System description for Blind Spot Intervention: Refer to "BLIND SPOT INTERVENTION SYSTEM : System Description" System Description.
- Normal operating condition: Refer to "Description" Blind Spot Warning & Blind Spot Intervention.

1. LDW/LDP SYSTEM ACTION TEST

Perform the LDW/LDP system action test. Refer to "Inspection Procedure" Inspection Procedure.
- GO TO 2.

2. CHECK BSW SYSTEM SETTING

1.Start the engine.
2.Check that the BSW system setting can be enabled/disabled on the navigation screen.
3.Turn OFF the ignition switch and wait for 5 seconds or more.
4.Check that the previous setting is saved when the engine starts again.
- GO TO 3.

3. BSW SYSTEM ACTION TEST

1.Enable the setting of the BSW system on the navigation screen.
2.Turn warning systems switch ON (warning systems ON indicator is ON).
NOTE:
Blind Spot Intervention system is OFF.
3.Check BSW operation according to the following table.





- GO TO 4.

4. CHECK BLIND SPOT INTERVENTION SYSTEM SETTING

1.Start the engine.
2.Check that the Blind Spot Intervention system setting can be enabled/disabled on the navigation screen.
3.Turn OFF the ignition switch and wait for 5 seconds or more.
4.Check that the previous setting is saved when the engine starts again.
- GO TO 5.

5. CHECK DYNAMIC DRIVER ASSISTANCE SWITCH

1.Start the engine.
2.After starting the engine wait for 5 seconds or more.
3.Enable the setting of the Blind Spot Intervention system on the navigation screen.
4.Press the dynamic driver assistance switch.
5.Check that the Blind Spot Intervention ON indicator on the combination meter illuminates.
6.Check that the Blind Spot Intervention ON indicator turns OFF when the system is turned OFF by pressing the dynamic driver assistance switch.
7.Check that the Blind Spot Intervention ON indicator turns OFF when the engine starts again.
NOTE:
- The Blind Spot Intervention ON indicator does not illuminate even when the dynamic driver assistance switch is turned ON within approximately 5 seconds after starting the engine.
- When the Blind Spot Intervention system setting is disabled on the navigation screen, the Blind Spot Intervention ON indicator is not turned ON by pressing the dynamic driver assistance switch.
- INSPECTION END