Trunk / Liftgate Hydraulic Cylinder: Service and Repair

BACK DOOR

BACK DOOR STAY : Removal and Installation


REMOVAL

1.Support back door lock with the proper material to prevent it from falling.

WARNING:
Body injury may occur if no supporting rod is holding the back door open when removing the back door stay.





2.Remove the metal clip (3) located on the connection between the back door stay (1) and the stud ball (2) (back door side) by using a flatted-blade screwdriver (A).
3.Remove back door stay (back door side).
4.In the same way, remove back door stay (body side).

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:
Check back door open/close operation after installation.