Back Door Support Rod

BACK DOOR LOCK

BACK DOOR SUPPORT ROD : Removal and Installation


REMOVAL

1.Remove cap of back door finisher side (LH). Refer to "Exploded View" Exploded View.





2.Remove stud ball (1) of back door support rod (3) from back door assembly (2).
3.Remove automatic back door control module. Refer to "Removal and Installation" Automatic Back Door Control Module.
NOTE:
When replacing back door support rod, replace stud ball and automatic back door control module as a set, since back door support rod is engaged and connected to stud ball and automatic back door control module.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- When reusing stud ball, always apply locking sealant before installing stud ball to back door.
- Check back door open/close operation after installation.