Special Repair Requirement

ADDITIONAL SERVICE WHEN REPLACING TRANSMISSION ASSEMBLY

Special Repair Requirement


1. PREPARATION BEFORE CALIBRATION PROCEDURE

1.Park the vehicle on a flat road.
2.Adjust pressure in all tires to the specified value. Refer to "Tire Air Pressure" [1][2]Specifications.
- GO TO 2.

2. PERFORM CALIBRATION

With CONSULT
1.Turn ignition switch ON.

CAUTION:
Never start the engine.
2.Select "G SENSOR CALIBRATION" in "Work Support" in "TRANSMISSION".
3.Touch "START".

CAUTION:
Never give any motion to the vehicle during the calibration.
Is "completed" displayed?
YES- GO TO 3.
NO- Perform the calibration again.

3. CHECK DTC

With CONSULT
1.Turn ignition switch OFF and wait 10 seconds or more.
2.Turn ignition switch ON.
3.Select "Self Diagnostic Results" in "ABS".
Is "C1145" or "C1146" detected?
YES- Refer to "DTC Index" Testing and Inspection.
NO- WORK END