Removal and Installation

TRANSFER HI-LO POSITION SENSOR

Removal and Installation


REMOVAL

1.Turn the ignition switch OFF.
2.Disconnect negative battery terminal.

CAUTION:
Wait for 5 seconds after turning ignition switch OFF.
3.Remove exhaust front tube (LH). Refer to "Removal and Installation" Removal and Installation.
4.Support transfer assembly and transmission assembly with a jack.
5.Remove front suspension rear cross member with a power tool. Refer to "4WD : Removal and Installation" Removal and Installation.
6.Remove rear engine mounting cross member with a power tool. Refer to "4WD : Removal and Installation" Removal and Installation.
7.Remove heat insulator of exhaust front tube (LH).
8.Lower jack to the position where the transfer Hi-Lo position sensor can be removed.
9.Disconnect the transfer Hi-Lo position sensor connector.
10.Remove the transfer Hi-Lo position sensor.
11.Perform inspection after removal. Refer to "Inspection" Inspection.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Never damage O-ring of transfer Hi-Lo position sensor.
- Perform inspection after installation. Refer to "Inspection" Inspection.