Diagnosis Procedure

TOUCH SENSOR

LH : Diagnosis Procedure


1. CHECK TOUCH SENSOR LH INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect touch sensor LH connector.
3.Check voltage between touch sensor harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK TOUCH SENSOR LH CIRCUIT

1.Disconnect automatic back door control module connector.
2.Check continuity between automatic back door control module harness connector and touch sensor LH
harness connector.





3.Check continuity between automatic back door control module harness connector and ground.





Is the inspection result normal?
YES- Replace automatic back door control module. Refer to "Removal and Installation" Automatic Back Door Control Module.
NO- Repair or replace harness.

3. CHECK TOUCH SENSOR LH GROUND CIRCUIT

Check continuity between automatic back door control module harness connector and touch sensor LH harness connector.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace harness.

4. CHECK TOUCH SENSOR LH

Refer to "LH : Component Inspection" Component Inspection.
Is the inspection result normal?
YES- GO TO 5.
NO- Replace touch sensor LH.

5. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END