Diagnosis Procedure

TOUCH SENSOR

RH : Diagnosis Procedure


1. CHECK TOUCH SENSOR RH INPUT SIGNAL

1.Turn ignition switch OFF.
2.Disconnect touch sensor RH connector.
3.Check voltage between touch sensor RH harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK TOUCH SENSOR RH CIRCUIT

1.Disconnect automatic back door control module connector.
2.Check continuity between automatic back door control module harness connector and touch sensor RH
harness connector.





3.Check continuity between automatic back door control module harness connector and ground.





Is the inspection result normal?
YES- Replace automatic back door control module. Refer to "Removal and Installation" Automatic Back Door Control Module.
NO- Repair or replace harness.

3. CHECK TOUCH SENSOR RH GROUND CIRCUIT

Check continuity between automatic back door control module harness connector and touch sensor RH harness connector.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace harness.

4. CHECK TOUCH SENSOR RH

Refer to "RH : Component Inspection" Component Inspection.
Is the inspection result normal?
YES- GO TO 5.
NO- Replace touch sensor RH.

5. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END