P0134
Steps 1 - 2:
Steps 3 - 7:
Steps 8 - 11:
DTC P0134 O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 1)
Circuit Description
The powertrain control module (PCM) supplies a bias voltage of about 450 mV between the heated oxygen sensor (HO2S) high and low circuits. When measured with a 10 MOHM digital voltmeter, this may display as low as 320 mV. The oxygen sensor varies the voltage within a range of about 1000 mV when the exhaust is rich, down through about 10 mV when exhaust is lean. The PCM constantly monitors the HO2S signal during "Closed Loop" operation and compensates for a rich or lean condition by decreasing or increasing injector pulse width as necessary. If the Bank 1 HO2S 1 voltage remains at or near the 450 mV bias for an extended period of time, Diagnostic Trouble Code P0134 will be set, indicating an open sensor signal or sensor low circuit. DTC P0134 is a type B code.
Conditions for Setting the DTC
- No related Diagnostic Trouble Codes.
- Engine run time is longer than 120 seconds.
- Oxygen sensor heater has been determined to be functioning properly, and the oxygen sensor has warmed to operating temperature.
All the above conditions are met and the following condition is met:
- Bank 1 HO2S 1 signal voltage remains between 400 mV and 500 mV for a total of 76.5 seconds over a 90-second period of time.
Action Taken When the DTC Sets
- The PCM will illuminate the malfunction indicator lamp (MIL) the second time the fault is detected.
- The PCM will store conditions which were present when the Diagnostic Trouble Code was set as Freeze Frame and in the Failure Records data.
- "Open Loop" fuel control will be in effect.
Conditions for Clearing the MIL/DTC
- The PCM will turn the MIL OFF on the third consecutive trip cycle during which the diagnostic has been run and the fault condition is no longer present.
- A history Diagnostic Trouble Code P0134 will clear after 40 consecutive warm-up cycles have occurred without a fault.
- Diagnostic Trouble Code P0134 can be cleared by using the Scan Tool's "Clear Info" function.
Diagnostic Aids
Check for the following conditions:
- Poor connection or damaged harness - Inspect the harness connectors for backed-out terminals, improper mating, broken locks, improperly formed or damaged terminals, poor terminal-to-wire connection, and damaged harness.
- Faulty HO2S heater or heater circuit - With the ignition ON engine OFF after a cool down period, the HO2S 1 voltage displayed on the Tech 2 is normally 455-460 mV. A reading over 1000 mV indicates a signal line shorted to voltage. A reading under 5 mV indicates a signal line shorted to ground or signal lines shorted together. Disconnect the HO2S and connect a test light between the HO2S ignition feed and heater ground circuits. If the test light does not light for 2 seconds when the ignition is turned on, repair the open ignition feed or sensor ground circuit as necessary. If the test light lights and the HO2S signal and low circuits are OK, replace the HO2S.
- Intermittent test - With the ignition ON monitor the HO2S signal voltage while moving the wiring harness and related connectors. If the fault is induced, the HO2S signal voltage will change. This may help isolate the location of the malfunction.
Reviewing the Failure Records vehicle mileage since the diagnostic test last failed may help determine how often the condition that caused the Diagnostic Trouble Code to be set occurs. This may assist in diagnosing the condition.