P0341
DTC P0341 Camshaft Position (CMP) Sensor Performance
Circuit Description
The Camshaft Position (CMP) Sensor indicates the camshaft position so that the Powertrain Control Module (PCM) can determine which cylinder is misfiring when a misfire is present. Whenever the PCM receives an intermittent signal from the CMP, then the CMP Resync Counter will increment. In order to set a DTC, the PCM must see a minimum number of resync's within a maximum time.
Conditions for Running the DTC
The engine is running.
Conditions for Setting the DTC
The PCM sees the cam resync counter is more than 15 counts in 256 seconds (4 min., 16 sec.).
Action Taken When the DTC Sets
- The control module illuminates the malfunction indicator lamp (MIL) if a failure is detected during 2 consecutive key cycles.
- The control module sets the DTC and records the operating conditions at the time the diagnostic failed. The failure information is stored in the scan tool's Freeze Frame and Failure Records.
Conditions for Clearing the MIL/DTC
- The control module turns OFF the MIL after 3 consecutive drive trips when the test has Run and Passed
- A history DTC will clear if no fault conditions have been detected for 40 warm-up cycles. A warm up cycle occurs when the coolant temperature has risen 22° C (40° F) from the startup coolant temperature and the engine coolant reaches a temperature that is more than 70° C (158° F) during the same ignition cycle.
- Use the scan tool Clear Information function
Diagnostic Aids
Whenever the PCM sees less than 15 resyncs in 256 seconds, the counter is reset to 0. Anytime a poor connection is present, the Cam Sensor Reference Activity counter will stop incrementing and the Cam Sensor Resync Counter will increment.
An intermittent may be caused by any of the following conditions:
- A poor connection
- Rubbed through wire insulation
- A broken wire inside the insulation
Thoroughly check any circuitry that is suspected of causing the intermittent complaint. Refer to Testing for Intermittent and Poor Connections.
If a repair is necessary, refer to Wiring Repairs or Connector Repairs.
Steps 1 - 3:
Steps 4 - 6:
Steps 7 - 10:
Steps 11 - 12:
Test Description
The numbers below refers to the step numbers on the Diagnostic Table.
1. The Powertrain OBD System Check prompts you to complete some of the basic checks and to store the freeze frame and failure records data on the scan tool if applicable. This creates an electronic copy of the data captured when the malfunction occurred. The scan tool stores this data for later reference.
3. This step determines if the DTC P0341 is the result of a hard malfunction or an intermittent condition.
4. The counter should stop incrementing with the sensor electrical connector disconnected and set a DTC P0342.If the counter stills increments, this indicates that the PCM is malfunctioning.
5. By moving the CMP sensor electrical connector, the connections at the sensor are being checked. Make sure that the electrical connector remains securely fastened.
6. A poor electrical connection in any of the circuits at the CMP sensor will cause the CMP Resync Counter to increment. Anytime a poor electrical connection is present, the CMP Reference Activity counter will stop incrementing and the CMP Resync Counter will increment.
7. Program the replacement PCM and perform the crankshaft position system variation procedure. Refer to the latest Isuzu Technical Communications System (ITCS) procedures for PCM programming.