P1295

DTC P1295 Power Management Mode




Circuit Description
- The throttle position (TP) sensor circuit provides a voltage signal relative to throttle position (blade angle)
The throttle blade angle will vary about 8% at closed throttle to about 92% at wide open throttle (WOT).
- The DC motor circuit provides a voltage signal relative to command throttle position (blade angle).
- The mass air flow (MAF) sensor measures the amount of air which passes through it into the engine during a given time. The powertrain Control Module (PCM) uses the mass air flow information to monitor engine operating conditions for fuel delivery calculations.
A large quantity of air entering the engine indicates an acceleration or high load situation, while a small quantity or air indicates deceleration or Idle.
The MAF sensor produces a frequency signal which can be monitored using a Tech 2. The frequency will vary within a range of around 4 to 7 g/s at Idle to around 25 to 40 g/s at maximum engine load.
- This DTC detects if the system is in Power Management Mode. (Fail safe Mode)

Conditions for setting the DTC
- The ignition is "ON".
- Power Management Mode is active. (Fail safe Mode)

Action Taken When the DTC Sets
- The PCM will illuminate the malfunction indicator lamp (MIL) the first time the fault is detected.
- The PCM calculates an air flow value based on Idle air Control valve position, throttle position, RPM and barometric pressure.
- The PCM will store condition which were present when the DTC was set as Freeze Frame and in the Failure Records data.

Conditions for Clearing the MIL/DTC
- The PCM will turn the MIL "OFF" on the third consecutive trip cycle during which the diagnostic has been run and the fault condition is no longer present.
- A history DTC P1295 will clear after 40 consecutive trip cycle during which the warm up cycles have occurred without a fault.
- DTC P1295 can be cleared using the Tech 2 "Clear Info" function or by disconnecting the PCM battery feed.

Diagnostic Aids
An intermittent may be caused by the following:
- Poor connections.
- Mis routed harness.
- Rubbed through wire insulation.
- Broken wire inside the insulation. Check for the following conditions:
- Poor connection at PCM - Inspect harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection.
- Damaged harness - Inspect the wiring harness for damage. If the harness appears to be OK, observe the TP sensor 1, TP sensor 2 display on the Tech 2 while moving connectors and wiring harnesses related to the sensor.

A change in the display will indicate the location of the fault. If DTC P1295 cannot be duplicated, the information included in the Failure Records data can be useful in determined vehicle mileage since the DTC was last set.

If it is determined that the DTC occurs intermittently, performing the DTC P1295 Diagnostic Chart may isolate the cause of the fault.

Steps 1 - 2:

Steps 3 - 7:

Steps 8 - 11:

Steps 12 - 16:

Steps 17 - 21:

Steps 22 - 23:

Test Description