B2961

DTC B2961

DTC Descriptor

DTC B2961
- Key In Ignition Circuit

Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure Diagnostic System Check - Vehicle






Circuit Description

The body control module (BCM) monitors the ignition key alarm switch. When the key is in the ignition, the ignition key alarm switch is closed and the signal circuit is low. When the key is not in the ignition, the ignition key alarm switch is open and the signal circuit is high.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

* The ignition 1 input is active and the key in ignition switch signal circuit is inactive (signal circuit is high).
* The above conditions must be present for more than 5 seconds.

Action Taken When the DTC Sets

The BCM stores DTC B2961 in memory.

Conditions for Clearing the DTC

* The DTC becomes history when the fault is no longer present.
* A history DTC will clear after 100 consecutive ignition cycles if the condition for the malfunction is no longer present.
* The BCM receives the clear code command from the scan tool.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the ignition switch.
2. Ignition OFF, test for less than 1 ohm of resistance between the ground circuit and ground.

• If greater than 1 ohm test the ground circuit for an open/high resistance.

3. Ignition ON, install a 3-amp fused jumper between the signal circuit and ground. Verify the scan tool Key In Ignition parameter displays Yes.

• If not Yes, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the BCM.

4. Ignition ON, engine OFF, verify the Ignition 1 parameter displays Off.

• If not Off, test the ignition 1 voltage circuit for a short to voltage.

5. If all circuits test normal, test or replace the ignition switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

* Ignition and Start Switch Replacement
* Control Module References for BCM replacement, setup, and programming