Vibration Damper - Installation

INSTALLATION










CAUTION: To prevent severe damage to the Crankshaft, Damper or Damper Installer 8512A, thoroughly clean the damper bore and the crankshaft nose before installing Damper.

1. Slide damper onto crankshaft slightly.

CAUTION: Special Tool 8512A, is assembled in a specific sequence. Failure to assemble this tool in this sequence can result in tool failure and severe damage to either the tool or the crankshaft.

2. Assemble Damper Installer 8512A as follows, thread nut (2) onto the bolt (3) then install the roller bearing (1) followed by the hardened washer (5) slides onto the threaded rod (3). Once assembled coat the threaded rod's threads with Mopar(R) Nickel Anti-Seize (or equivalent).
3. Using Damper Installer 8512A, press damper onto crankshaft.
4. Install then tighten crankshaft damper bolt to 176 Nm (129 ft. lbs.).
5. Install radiator upper hose.
6. Install accessory drive belt Serpentine Accessory Drive Belt - Installation.
7. Refill cooling system Service and Repair.
8. Connect negative cable to battery.