Intake Manifold - Removal

REMOVAL





1. Remove engine cover (1).
2. Bleed fuel system Service and Repair.
3. Disconnect negative cable from battery.
4. Remove air inlet hose.
5. Remove ignition wires from on top of intake manifold.

6. Disconnect electrical connectors for the following components:
- Manifold Absolute Pressure (MAP) Sensor
- Fuel Injectors
- Electric Throttle Control (ETC)

7. Remove wire harness from intake manifold.
8. Disconnect brake booster hose, purge hose, and Make Up Air (MUA) hose.
9. Remove EGR tube from intake manifold.
10. Remove intake manifold retaining fasteners in a crisscross pattern starting from the outside bolts and ending at the middle bolts.
11. Remove intake manifold as an assembly.