Airbag System Verification Test

AIRBAG SYSTEM VERIFICATION TEST
AIRBAG SYSTEM VERIFICATION TEST
1. Remove all special tools and jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

2. Connect the scan tool to the Data Link Connector - use the most current software available.
3. With the scan tool, erase stored DTCs in all Airbag System Modules.
4. Turn the ignition off, and wait 30 seconds, then turn the ignition on.
5. Wait one minute, and read active DTCs in all Airbag System Modules.
6. Read the stored DTCs in all Airbag System Modules.

Are any DTCs present or if the original condition still present?

Yes

- Repair is not complete. Perform the appropriate DTC. Testing and Inspection.

No

- Repair is complete.