Center Console - Installation

INSTALLATION





1. Position the console (4) over the shifters and brake levers and seat the clips (3) fully.
2. Install the four screws (1).





3. Connect the electrical connector (1).





4. Position the bezel (2) over the shifters and brake lever and seat the clips fully.
5. Install the cup holder and ash receiver (1), if equipped.





6. If equipped, position the transfer case shifter knob onto the shift shaft, a audible click should be heard when the shifter knob is fully seated.





7. If equipped, position the manual transmission shifter handle (2) onto the shift shaft (1) and install the bolt (3).
8. Tighten the bolt (3) to 33 Nm (24.5 ft. lbs.)





9. Seat the shifter boot (2) onto the console bezel (1) and seat fully.
10. Connect battery negative cable.