C1605

C1605

Component Location:

General Description
The HECU send requirement data, such as Torque reduction, the number of fuel cut cylinders, and ESC control requests, to the Engine ECU & TCU through CAN bus line.
The Engine ECU performs fuel cut functions according to requests from the HECU and retards ignition timing by torque reduction requests.
The TCU maintains current gear positions during ESC control time, in order not to increase power which causes a Kickdown shift.

DTC Description
The HECU checks the CAN control module for normal ESC control, and sets this code if CAN control module malfunction is detected.

DTC Detecting Condition:

Component Inspection
1. Ignition "OFF".
2. Engine "ON".
3. Does warning lamp remain On?

YES - Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to "Verification of Vehicle Repair" procedure.

NO - Fault is intermittent caused by faulty HECU or was repaired and HECU memory was not cleared, go to "Verification of Vehicle Repair" procedure.

Verification of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode
2. Using a scantool, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition in General Information.
4. Are any DTCs present?

YES - Go to the applicable troubleshooting procedure.

NO - System performing to specification at this time.