Seat Cover: Service and Repair

Service repair no - 78.30.01/81

Remove
1. Remove front seat. Service and Repair





2. Remove bolt securing seat belt stalk.
3. Remove seat belt stalk.





4. Remove 2 screw covers.
5. Remove 3 screws securing inner side finisher.
6. Remove side finisher.





7. Remove cable ties securing harnesses to seat base and disconnect multiplugs from outstation.
8. Release airbag harness 2 way connector from bracket.





9. Remove 2 screw covers.
10. Remove 2 screws securing outer side finisher.
11. Release switch harness and remove side finisher.





12. Remove 2 clips securing squab cover to cushion frame and release squab cover retainer.





13. Remove 4 Torx screws securing squab assembly to cushion assembly.
14. Remove cushion assembly from squab assembly.





15. Remove 10 clips securing cushion cover to frame.





16. Release 2 retainers securing cover to frame.
17. Remove 2 studs securing cover to frame.
18. Remove cover and foam assembly from frame.
Do not carry out further dismantling if cover and foam is removed for access only.





19. Remove 15 hog rings securing cover to foam. Remove cover.
20. Remove retention wires from pockets in cover.
21. Remove side finisher retaining wire from cushion cover retainer.

Refit
22. Fit side finisher retaining wire and retention wires to cover.
23. Position cover to foam align retention wires and fit hog rings.
24. Fit cover and foam assembly to frame.
25. Fit studs securing cover and secure retainers.
26. Fit clips securing cover.
27. Using assistance, position cushion assembly to squab assembly.
28. Fit Torx screws securing cushion assembly to squab assembly and tighten to 30 Nm (22 ft. lbs.).
29. Secure squab retainer and fit clips.
30. Position outer side finisher and feed harness through, locate finisher and fit screws and covers. Connect multiplugs to outstation.
31. Fit outer side finisher, fit screws and screw covers.
32. Secure airbag harness connector to bracket.
33. Align harnesses and secure with cable ties.
34. Position seat belt stalk, fit bolt and tighten to 35 Nm (26 ft. lbs.).
35. Fit seat. Service and Repair