Operation CHARM: Car repair manuals for everyone.

Rear Quarter Trim Panel





Rear Quarter Trim Panel
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures

Removal









1 Remove the loadspace scuff plate.




2 Release the liftgate seal.












3 Release the rear door seal.








4 If installed, remove the loadspace
lamp.




5 Remove the rear quarter trim panel.





NOTE:
Do not disassemble further if the component is removed for access only.
6 Remove the 7 clips.




7 Remove the access cover.

Installation
1 Install the access cover.
2 Install the clips.
3 Install the rear quarter trim panel.
4 Install the loadspace lamp.
5 Install the loadspace roller blind.
6 Secure the rear door seal.
7 Install the loadspace securing ring and tighten the Torx screw.
Torque to: 25 Nm
8 Install the loadspace stowage tray.
9 Secure the liftgate seal.

10 Install the loadspace scuff plate.

11 Install the spare wheel cover.