Operation CHARM: Car repair manuals for everyone.

Electronic Brake Control Module: Service and Repair





Anti-Lock Brake System (ABS) Module
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures

Removal

CAUTION: Extreme cleanliness must be exercised when handling these components.

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

All vehicles

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
2 Disconnect the battery ground cable.
For additional information, refer to Specifications [1][2]Specifications
3 Remove the battery tray.
For additional information, refer to Battery Tray Service and Repair

Right-hand drive vehicles
4 Remove the plenum chamber panel.

Left-hand drive vehicles
5 Remove the windshield wiper motor and linkage.
For additional information, refer to Windshield Wiper Motor Service and Repair





CAUTION: Make sure that all openings are sealed.

All vehicles













Left-hand drive vehicles





CAUTION: Be prepared to collect escaping fluids.

CAUTION: Make sure that all openings are sealed.

Right-hand drive vehicles





CAUTION: Be prepared to collect escaping fluids.

CAUTION: Make sure that all openings are sealed.

All vehicles





CAUTION: Be prepared to collect escaping fluids.

CAUTION: Make sure that all openings are sealed.

Installation
All vehicles
1 Install the ABS module.
Torque to: 10 Nm
2 Install the brake fluid tubes.
Torque to: 15 Nm
3 Install the battery tray support.
M6: 10 Nm
M8: 25 Nm

Left-hand drive vehicles
4 Connect the brake booster vacuum line.

All vehicles
5 Install the ECM.
6 Secure the vacuum line and harness.

Left-hand drive vehicles
7 Install the windshield wiper motor and linkage.
For additional information, refer to Windshield Wiper Motor Service and Repair

Right-hand drive vehicles
8 Install the plenum chamber panel.

All vehicles
9 Install the battery tray.
For additional information, refer to Battery Tray Service and Repair

10 Connect the battery ground cable.
For additional information, refer to Specifications [1][2]Specifications

11 Bleed the brake system.
For additional information, refer to Brake System Bleeding Service and Repair

12 If a new component has been installed, configure using Land Rover approved diagnostic equipment.