Glove Compartment: Service and Repair

Glove Compartment

Special Service Tools






Glove compartment hinge pin remover

501-113

Removal





1 Remove the closing trim panel.
- Release the clip.
- Remove the 2 screws.
- Disconnect the electrical connector.




2 Open the glove compartment to the service condition.
- Release the glove compartment latch stops.




3
CAUTION: If the hinge pin will not release, rotate the pin through 90 degrees to aid removal.
Using the special tool, remove the glove compartment.
- Apply pressure to the head of the hinge pin and install the special tool. Remove the hinge pin.
- Repeat the above procedure for the remaining hinge pin.

Installation
1 Install the glove compartment.
- Install the hinge pins.
2 Close the glove compartment.
- Secure the latch stops.
3 Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.