B-Pillar Upper Trim Panel

B-Pillar Upper Trim Panel

Removal
1 Make the SRS system safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Remove the B-pillar lower trim panel. For additional information, refer to B-Pillar Lower Trim Panel B-Pillar Lower Trim Panel




3 Release the safety belt lower anchor from the seat.
- Remove the bolt cover.
- Passenger side, disconnect the electrical connector.
- Remove the Torx bolt.




4
NOTE:
Make sure the seat belt height adjuster is at its lowest point prior to removal of the B-pillar upper trim panel.
Remove the B-pillar upper trim panel.
- Release the front and rear door weatherstrips for access.
- Release the 2 lower clips, then the remaining upper clip.
- Release the safety belt.

Installation
1 Install the B-pillar upper trim panel.
- Secure with the clips.
- Attach the safety belt.
- Attach the door weatherstrips.
2 Attach the safety belt lower anchor to the seat.
- Tighten the Torx bolt to 40 Nm (30 lb.ft).
- Passenger side, connect the electrical connector.
- Install the bolt cover.
3 Install the B-pillar lower trim panel. For additional information, refer to B-Pillar Lower Trim Panel B-Pillar Lower Trim Panel