Suspension Control Module: Service and Repair

Air Suspension Control Module

Removal
1 Driver side: Remove the cowl side trim panel. For additional information, refer to Cowl Side Trim Panel Cowl Side Trim Panel




2 Remove the closing trim panel.
- Release the clip.
- Remove the 2 screws.
- Disconnect the electrical connector.




3 Remove the air suspension control module.
- Disconnect the 4 electrical connectors.
- Remove the bolt.
- Release from the 2 clips.

Installation
1 Install the air suspension control module.
- Secure with the clips.
- Connect the electrical connectors.
- Tighten the bolt to 9 Nm (7 lb.ft).
2 Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.
3 Install the cowl side trim panel. For additional information, refer to Cowl Side Trim Panel Cowl Side Trim Panel
4 Initiate a new control module using T4.