Operation CHARM: Car repair manuals for everyone.

Front Door Window Regulator: Service and Repair





Front Door Window Regulator and Motor

Removal
1 Remove the front door trim panel. For additional information, refer to Front Door Trim Panel
2 Remove the front door window glass. For additional information, refer to Front Door Window Glass Service and Repair




3 Remove the speaker.
- Disconnect the electrical connector.
- Remove the 4 screws.




4 Remove the glass guide channel.
- Release the channel lining.
- Remove the bolt.




5
NOTE:
Rotate the assembly within the aperture through 90 degrees and release the upper edge from the rear side of the aperture first.
Remove the window motor and regulator assembly.
- Disconnect the electrical connector.
- Remove the 4 bolts.
- Remove the 2 nuts.

Installation
1 Install the window motor and regulator assembly.
- Tighten the bolts and nuts to 10 Nm (7 lb.ft).
- Connect the electrical connector.
2 Install the glass guide channel.
- Tighten the bolt to 10 Nm (7 lb.ft).
- Install the channel lining.
3 Install the speaker
- Align the door wiring harness clip.
- Tighten the screws.
- Connect the electrical connector.
4 Install the front door window glass. For additional information, refer to Front Door Window Glass Service and Repair
5 Install the front door trim panel. For additional information, refer to Front Door Trim Panel